3. To set date and time automatically:
a. In Set date and time, select Automatically.
b. Select Time zone.
c. In NTP server addresses, configure the Network Time Protocol (NTP) servers that the
transmitter will attempt to synchronize with.
NTP synchronization requires that the transmitter has a network
connection and the IP address of the NTP server is reachable.
d. Select Date format and Time format.
4. To set date and time manually:
a. In Set date and time, select Manually.
b. Select Time zone.
c. In Date and time, select Day, Month, Year, and Time. Then select Set.
d. Select Date format and Time format.
The new date and time appears at the lower right corner of the touchscreen.
More information
‣
Configuring home views on touchscreen (page 48)
‣
Configuring analog outputs on touchscreen (page 49)
‣
Configuring relays on touchscreen (page 52)
‣
Enabling Modbus TCP/IP on touchscreen (page 55)
5.2
Starting up transmitter using web interface
The transmitter has a web interface for remote access. Take the following steps to start using
the transmitter via the web interface.
Indigo 520 User Guide M212287EN-A
38
To Next Page
Loading...
