7.2 Configuring analog outputs in web interface
You need Administrator user rights for this task.
Figure 25 Analog outputs configuration menu in web interface
1. Connect to the web interface.
2. Log in to the web interface as an administrator user.
3. Select Outputs > Analog outputs.
4. In the General tab, define the settings that are common for all analog outputs:
a. In Output mode, select the current or voltage range for the outputs.
b. In Error output, define the output level indicating that the device is in error state or
that the measurement outside the defined measurement scale.
c. Select Apply.
5. In the tabs Output 1 … 4, select the output channel you want to configure.
Chapter 7 – Configuring transmitter using web interface
57
To Next Page
Loading...
