6. Configure the analog output channel settings:
a. In Output o/on, set the output channel o to edit settings.
b. In Source, select the source for the measurement parameter that controls the output
channel.
c. In Parameter, select the measurement parameter that controls the output channel.
d. In Scale low end and Scale high end, define the lower and upper ends of the
measurement scale for the chosen output parameter.
e. Set the output channel on.
f. Select Apply.
7. Repeat step 5 … step 6 for all the analog output channels you want to use.
More information
‣
Analog output configuration example (page 52)
7.3
Configuring relays in web interface
You need Administrator user rights for this task.
Indigo 520 User Guide M212287EN-A
58
To Next Page
Loading...
