Chapter 3 ________________________________________________________________ Installation
VAISALA ________________________________________________________________________ 25
Pole installation
NOTE
Recommended pole diameter for HMS82/83
/TMS82 installation with the
supplied clamp and screws is 25 ... 60 mm.
1. Use the supplied clamp and screws to mount the transmitter on a
pole.
2. To prevent the transmitter from turning on the pole, tighten the set
screw on the center hole of the clamp.
1304-054
Figure 15 HMS82/83 Pole Installation
3. Plug in the screw terminal block, close the cover, and tighten the
screws.
4. Secure the cable to the pole using a zip tie. Allow some cable to
hang down from the cable gland to prevent water from entering the
transmitter along the cable.
1304-056
Figure 16 Securing the Cable on a Pole
To Next Page
Loading...
