User's Guide _______________________________________________________________________
26 ___________________________________________________________________ M211510EN-E
Wall installation
1. Drill two holes for wall plugs 100 mm apart.
2. Place the wall plugs in the holes.
3. Mount the transmitter using two screws of sufficient length.
1304-055
Figure 17 HMS82/83 Wall Installation
4. Plug in the screw terminal block, close the cover, and tighten the
screws.
5. Secure the cable to the wall using cable ties. Allow some cable to
hang down from the cable gland to prevent water from running to
the transmitter along the cable.
1304-057
Figure 18 Securing the Cable on a Wall
To Next Page
Loading...
