Chapter 4 _________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 101
CHAPTER 4
OPERATION
This chapter provides the instructions for taking MAWS Automatic
Weather Station into use when all the equipment has been assembled
and installed.
Operation Principle
MAWS works based on a so-called setup. Setup is a program that tells
MAWS what to measure, log, calculate, and report. Measured data is
stored in the daily log files that can be downloaded to a PC and
viewed using the MAWS Terminal software.
The Basic setup has been loaded in the MAWS program memory
already at the factory. This allows you to just connect the sensors,
connect communication lines, and supply power to MAWS. Then
your station will start operating: making measurements, doing
calculations and sending report(s).
On the MAWS CD-ROM, delivered to you with the system, you will
find several setup examples, named as DEMOx. The delivered setups
will suit typical needs, but you may want to make changes to them.
For reconfiguring the setup files or making totally new ones, refer to
the MAWS Lizard software User's Guide listed in Table 2 on page 15.
To Next Page
Loading...
Need help?
General
