User's Guide _______________________________________________________________________
54 ___________________________________________________________________ M210243en-A
3. When you have the PMT16A pressure sensor (1) installed on the
logger, attach the tube that comes from the blue inlet (3) into the
outlet (2) of the logger housing. The tube should cover at least 5
mm of the outlet. Make sure that the tube is not blocked or bent
during the transportation.
0201-019
Figure 36 Pressure Sensor Tube Connection
4. The internal battery should always be installed when the weather
station is in operation. The battery supplies backup power to the
station and is needed for keeping the time and date information.
To insert the internal battery, you may have to bend battery
terminals. Connect the flat connectors to battery terminals (1 &
2). Connect the red wire to the positive pole (+), and the black
wire to the negative pole (-). The battery lead(s) is disconnected
during shipping. It is recommended to disconnect the lead also if
the station is not used for several weeks (no charging). When
storing the station for a few days, use SLEEP command to
reduce the power consumption and discharging the battery.
To Next Page
Loading...
