Vaisala MAWS101 - Installing Wind Sensor; Aligning Wind Vane; Figure 64 PMT16 A Location on the Logger; Using Winddircal0 Command

Chapter 3 ________________________________________________________________ Installation
VAISALA ________________________________________________________________________ 73
0201-033
Figure 64 PMT16A Location on the Logger
Installing Wind Sensor
Before installing the sensor itself, you have to mount the wind sensor
mast to the upper base of the tube. After you have installed the mast,
you can mount the wind sensor on top of it. For more information, see
Figure 40 on page 56.
Aligning Wind Vane
Using winddircal0 Command
1. Turn the nose (1) of the vane to a known point of compass (e.g.
north).
2. Give command winddircal0 with the known direction reading
(e.g. winddircal0 360. This will set the current direction to the
north, 360 degrees).