5. Remove the master board.
6. Remove the interface
board.
8. Insert master board and interface board
in reverse order as disassembled at
correct positions (see steps 6 to 5).
9. Insert option board at correct position
(see step 7)
10. Reconnect fan cable (see step 4)
11. Place the panel and tighten screws with
1.1 Nm (see steps 3 to 2)
Pozidriv screw driver size
1
12. Tighten female screw locks from
POWER, SENSOR and INTERFACE
connectors with 1.1 Nm (see step 1)
If you need any further information, please contact one of our service centers. You
can find the addresses on our website: www.vatvalve.com.
To Next Page
Loading...
