Vatech Green X User Manual

1. Introduction
Green X / X18 (Model: PHT-75CHS) Installation Manual 1
English
1. Introduction
1.1 Manufacturer's Liability
As the manufacturer, VATECH assumes liability for the safe and reliable installation
and operation of this equipment only when:
 Equipment installation, including software installation, was conducted by an
authorized agent by this installation manual.
 The electrical installation was conducted to the appropriate requirements
specified in IEC-60363.
 Genuine original or approved replacement parts are used.
 Maintenance/repair service has been performed by a qualified technician(s) from
one of our authorized agents.
 The equipment has been used under normal conditions according to the user
manual.
 PC software is properly used according to the manufacturer’s installation and
user manual.
1.2 Customer’s Responsibility
Site planning and preparation are the responsibility of the customer. The following
points should be considered fundamentally important to all customers of this product:
 Install all required materials before the delivery of the system.
 Before installing the equipment, complete the room's floor, ceiling, and walls.
 Install proper-sized junction boxes, with covers, at the necessary locations.
 Install a mains power with the proper voltage output and an adequate kVA rating.
 Install the circuit breaker specified by this manual.
 Provide the installer(s) with the current dimensions of the room, including the
hallway and entry door sizes.
 The customer must have an electrician install more than two power outlets in the
room.

Vatech Green X Specifications

General

Brand	Vatech
Model	Green X
Category	Diagnostic Equipment
Language	English