Need help?Do you have a question about the Vatech Green X and is the answer not in the manual?
General| Sensor Type | CMOS |
|---|---|
| Resolution | High Resolution |
| X-ray Generator | High Frequency |
| Focal Spot Size | 0.5 mm |
| Compatibility | DICOM 3.0 |
| Imaging Technology | Cone Beam Computed Tomography (CBCT) |
| Current Range | 4-10 mA |
| Power Supply | 220-240 VAC |
| Voxel Size | Down to 80 microns |
| Voltage Range | 60-90 kV |
| Software Compatibility | Ez3D-i |
Step-by-step guide for attaching the base to the X-ray unit.
Instructions for fixing the base of the X-ray unit to the floor.
Procedure for leveling the X-ray unit using a spirit level.
Instructions for connecting wall and column brackets.
Overview and initial steps for installing the wall-mount type X-ray unit.
Refers to section 4.2 for CEPH unit installation.
Refers to section 4.3 for bracket installation.
Procedure to level the equipment using a spirit level.
Steps for attaching the X-ray unit to the wall structure.
Specifies the hardware and software requirements for the PC.
Steps to add exclusions to Windows security for proper operation.
Steps to disable the Windows firewall for uninterrupted operation.
Configuring anti-virus software to exclude specific folders.
Instructions for installing image viewer programs like EzDent-i.
Step-by-step guide for installing the InstallShield software.
Configuring EzDent-i and console software parameters.
Steps to start the imaging program within EzDent-i.
Configuring various parameters within the console software.
Procedure to disable packing mode for system operation.
Details power supply voltage, frequency, power rating, and accuracy.
Checklist for installers' actions during equipment installation.
To Next Page
