MC 2.0 WL VDO CYCLECOMPUTING
DE ENG FR ESIT NL PL
5.2 Installing the battery in the computer >>> P07
5.3 Inserting the computer into the handlebar bracket >>> P08
Your VDO computer comes without battery built in.
Before you start, please insert battery.
Step Open the battery compartment lid with a coin.
Step Place the battery in the computer casing with the +terminal
pointing up.
Step Make sure that the battery does not tilt.
Step Ensure that the rubber seal lies flat on the battery
compartment lid.
The VDO twist-click system securely connects the computer to the
handlebar bracket.
Step Place the computer into the bracket in a o'clock position.
Step Twist the computer to the right until reaching the o'clock
position and click it into the bracket system.
Step Insert the battery compartment lid into the opening and use
a coin to turn it to the right as far as it will go (approx. ⅓ turn).
Step After inserting the battery, the computer will start the language
select-mode. See chapter .
TIP for changing batteries: VDO recommends changing the battery
annually. Buy a new battery in good time to ensure the wireless
transmission works perfectly. When the battery is changed,
all settings and all trip totals are saved.
Step To remove the computer, twist it to the left
(do not push or pull).
How to remember: Rigid to the Right, Loose to the Left
Step Guide the cable ties through the slot in the handlebar bracket,
place around the handlebars or the stem and pull (do not pull tight
just yet).
Step If fitting to handlebars: align the computer angle to achieve
optimum readability. Now pull the cable ties tight. Snip off protruding
ends with clippers.
To Next Page
Loading...
