VDO MC 2.0 WL - Setting the Altitude Loss Downhill

ITNLPL FRES ENG DE
www.vdocyclecomputing.com MC 2.0 WL 
ALTI UP--ALTI UP  or  is shown on the display.
Press ALTI
A
or
P
to make a selection.
Press
M
in confirmation.
ALTI UP --SET METER or FEET appears on the display.
The first digit of the altitude reading flashes.
Press ALTI
A
to reduce the value or
P
to increase it.
Once you have set the correct value, press
M
to confirm your setting.
The second digit flashes.
Press ALTI
A
to reduce the value or
P
to increase it.
Once you have set the correct value, press
M
to confirm your setting.
Continue the setting process until all digits have been set.
ALTI UP --SET OK?
Press
M
in confirmation.
The MC . confirms by displaying ALTI UP --SET DONE.
To exit settings mode, press and hold the
C
button for three seconds.
SETTINGS--CLOSE? flashes. The MC . switches back to function mode.
6.14 Setting the altitude loss downhill
The altitude loss downhill can be separately set for bike  and bike .
Before the start of the season, you can reset the total altitude loss to
zero.
ATTENTION: the total altitude loss is SAVED when the battery is
changed. The data is not lost.
Process:
Press and hold
M
for three seconds. SETTINGS--OPEN? flashes.
LANGUAGE---SELECT--- appears on the display.
Press
P
to scroll to ALTI DOWN---SET---.
Press
M
in confirmation.