ITNLPL FRES ENG DE
www.vdocyclecomputing.com MC 2.0 WL
ITNLPL FRES ENG DE
www.vdocyclecomputing.com MC . WL
9. Troubleshooting
Error Possible cause Correction
Half segments on the display
(e.g. after a battery change)
Computer software not running
correctly after battery change
Take out the battery, wait a few seconds,
place battery back again
No speed displayed Distance from sensor to magnet too great Correct the sensor and magnet positions
No speed displayed Computer not properly clicked
into the handlebar bracket
Place the computer head in the handlebar
bracket and twist it until it clicks
No speed displayed Wheel circumference is not correctly set or
is at zero
Set the wheel circumference
No speed displayed Battery in the transmitter is dead Replace the battery in the transmitter
No speed displayed Speed transmitter has not been paired Insert the computer into the handlebar
bracket, speed indicator flashes, now turn
the front wheel, transmitter is paired,
speed is displayed
Speed doubled Magnet is incorrectly positioned Correct the position of the magnet
on the spoke
Display becomes weak Battery dead Check the battery, replace if nec.
Display becomes weak Temperatures under ° make the display
sluggish
At normal temperatures the display
will work normally again
Incorrect altitude displayed
(current altitude incorrect)
Air pressure has changed but the current
altitude has not been recalibrated in line
with the new air pressure
Recalibrate the current altitude
To Next Page
Loading...
