DSGH Installation and Operation Guide 13
Introduction
Storing the equipment
Source holder
If you must store it, do so in a clean, dry area. Be sure its shutter is in the
OFF or CLOSED position (if applicable). Check the current local regulations
(U.S. NRC, Agreement State, or other) to determine whether this area must
have any restrictions.
Gauge
Avoid storage at temperatures below freezing. Store the gauge indoors in
an area that has temperature control between +10 °C ... +35 °C (+50 °F ...
+95 °F) and < 50% relative humidity. Store equipment in dry conditions until
installation.
Certifications
This gauge is designed for certification compliance from the following
agencies”
• ATEX Standard
• CCOE (India)
• CEPEL/INMETRO (Brazil)
•CSA
• FM Standard
•IECex
•JIS (Japan)
• NEPSI (China)
To Next Page
Loading...
