Vega DSGH - New Hardware Tab; Responding to the New Hardware Found Message; When New Hardware Is Installed; When New Hardware Is Not Installed

62 DSGH Installation and Operation Guide
Advanced functions
New Hardware tab
Responding to the New hardware found message
When new hardware is installed
When you install a new CPU board or sensor assembly, you must verify
installation in Ohmview 2000 to enable new backups of the EEPROMs.
Procedure 4.3: To verify the “New Hardware Found” message
When new hardware is not installed
If the error message New hardware found appears, an EEPROM is probably
corrupt.
The messages “CPU EEPROM Corrupt” or “Sensor EEPROM Corrupt” may
also appear in the history.
1. Select Diagnostics | New hardware | New CPU or New Sensor.
2. Click OK.