Vega DSGH - Wiring

32 DSGH Installation and Operation Guide
Installation
Table 2.1 Conduit Torque Specifications
Table 2.2 GEN2000 Adapter and Plugs
Wiring
Use the drawing notes and the steps that follow to make the input and
output connections. Make the connections at the removable terminal
strips mounted on the power board. To access the power board, remove
the explosion-proof housing cap.
Normal Size of Conduit Torque
Inches lb/ft (N/m)
1/2, 3/4 67 (90)
1, 1-1/4 and 1-1/2 83 (113)
Millimeters lb/ft (N/m)
M16 & M20 23.9 (32.5)
Part Number Description Material
Plugs
221710 3/4
" NPT Pipe Plug Galvanized
221716 3/4" NPT Pipe Plug SQ HD 316SS
EEXD Approved
2.36361 1/2
" NPT Pipe Plug Aluminum
2.44134 3/4" NPT Pipe Plug 316SS
246681 M20 x 1.5 Stop Pipe Plug Brass
Adapters
EEXD Approved
248000 3/4
"NPT to 1/2" NPT Brass/unplated
247184 3/4
" NPT to M20 x 1.5 Brass/unplated
2.41660 3/4" NPT to M20 x 1.5 316SS
Note: If you received an interconnect drawing from VEGA or the
engineering contractor and the instructions differ from the
instructions in this manual, use the drawing. It may contain
special instructions specific to your order.