Chapter 2 Battery installation 11
LIEBERT APM UPS Module And Parallel System 30kVA~150kVA User Manual
Installation procedures of Battery Modules
When installing battery modules always work from the lower available space upwards to prevent raising the center of
gravity.
1. Open the front door
2. Insert the module in the installation position, and push it into the cabinet.
3. Secure the module to the cabinet trough the fixing holes on both side of the front panel of the module
1.4.10 Cable Entry
Cables can enter the LIEBERT APM series UPS rack system and battery cabinet from below. Cable entry is made
possible through a blanking plate fitted at the bottom of the equipment. The recommended installation practice is to
install glands to prevent foreign material or vermin entering the cabinet.
To Next Page
Loading...
