Vertiv | Liebert® CRV4 | User Manual 22
Mechanical Installation
3.2.3. Assembly of the Cabinet Parts
Assembling the parts of the cabinet which are supplied with the Liebert® CRV4 unit accessories. This also
includes the cabinet connectors which is used to connect the unit with adjacent cabinets.
Before connecting the cabinet, level the cabinet as mentioned in the previous section (refer to section
‘Leveling the cabinet’ for in-depth information).
Procedures of xing the cabinet
1. Loosen the xing screw of the cabinet connector on the frame of the cabinet. Figure 3-10 shows magnied
view of the cabinet connector.
2. Rotate the cabinet connector by 90° to the horizontal position. Use M5 countersunk head screws to x it on
the cabinet frame (side of the door lock), as depicted in right image of Figure 3-10.
No. Description
1 Cabinet connector
Figure 3-10 Rotating the Cabinet Connector
3. Use the M5 countersunk head screws to x the cabinet connectors (L-shaped) in the installation holes of
the cabinet frame (side of the hinge) and rack frame adjacent to the cabinet as shown in Figure 3-11.
To Next Page
Loading...
Need help?
General
