4.4 Unpacking the Unit—All Unit Sizes
Refer to Figure 4.2 on the next page, for the following steps:
1. For domestic packaging:
• Remove the fastener clamps from the top and sides of the unit.
• Remove all screws and washer from the wooden fencing.
• Remove the fence
–or–
For export packaging, remove the crate.
2. Carefully remove the steel straps securing the unit to the skid.
CAUTION: Risk of unsecured strap ends with sharp edges flying uncontrollably in any direction when cut.
Can cause serious injury. Secure both ends of each strap when cutting and wear OSHA approved protective
headgear, gloves and eye protection when working with the securing straps.
3. Set the legs aside, but keep accessible.
• Depending on the number of fans, more or less steel straps may be removed at this step.
4 Equipment Inspection and Handling
19
To Next Page
Loading...
