9. Refer to Figure 4.6 below, to attach rigging for lifting.
Spreader bars are still required. Make sure that the spreader bars are wider than the unit.
• 1 fan, 2 fan and 3 fan units: Route the straps through the large holes in the side of the legs.
• 4-fan units: Secure straps or chains to the eye bolts on top of the unit.
NOTICE
Risk of improper lifting. Can cause equipment damage. Make sure that the spreader bars are wider than the
unit. If the spreader bars are too short, the slings may crush the unit.
The unit is ready to be lifted and moved to its installation location.
Figure 4.6 Rigging to Lift 1 to 4 Fan Drycoolers
Vertiv | Liebert® Drycooler Installer/User Guide
24
To Next Page
Loading...
