4.7 Mounting the Drycooler
The drycooler must be installed so that it is level within 1/2in.(13mm) to ensure proper glycol flow, venting, and drainage.
For roof installation, mount the drycooler on suitable curbs or other supports. Follow all local and national codes. Secure the
legs to the mounting surface using a field-supplied 1/2-in.(13-mm) diameter bolt in each of the two 9/16-in. (14-mm) holes in
each leg. For anchor dimensions, refer to the appropriate drawing for your unit model included in the Submittal Drawings
Contents on page65.
4 Equipment Inspection and Handling
29
To Next Page
Loading...
