3 2
39
5 Use
Starting using the spring starter
(option)
9 Starting
• Remove the handle (3) from the starter.
note
The starter must NEVER be tripped with
the winding handle in place.
• Now start the engine by moving the trip le-
ver (2) through 90 degrees until it holds out.
Throttle back as soon as the engine runs.
Leave the key in the ‘ON’ position while the
engine is running.
note
If the engine does not start rst time, allow it
to come to a complete rest before retrying.
VD02008
VD02007
Caution
Never leave the spring starter part-
wound.
note
It is possible to unwind the starter, should
the need occur, by turning the handle
anti-clockwise. Additional force will be
required to overcome the initial friction.
To Next Page
Loading...
