Vetus M2.13 - Checking and Cleaning the Raw Water Strainer

52
6 Maintenance
Checking and cleaning the raw water strainer
Daily, before starting.
9 Checking the raw water strainer
• Check daily whether there is any dirt in the
raw water strainer.
10 Cleaning the strainer
• Close the seacock before removing the lid
of the water strainer.
• Clean the raw water strainer as often as is
necessary, depending on the pollution of
the waterways, but at least once every 6
months. A clogged raw water strainer will
result in excessive temperatures or over-
heating of the engine coolant.
• Check the sealing between the lid and
housing after cleaning and re-assembling
the strainer. An improperly sealed lid will re-
sult in air sucked in by the sea water pump
which again will result in overheating of the
engine.
VD00802 VD00801
note
Only engines with intercooling!