Vetus M2.13 - V-Belt Inspection and Tensioning

74
6 Maintenance
Checking the V-belt
Every 500 operating hours.
49 Remove the V-belt protection cover
• Loosen the the screws -the screws can be
loosened without tools and they have anti-
loss rings- and remove the V-belt protec-
tion.
50 Inspection V-belt
• Inspect the belt for wear and tear (fraying
and cracking). Belts which are in poor con-
dition should be replaced.
For V-belt art. code see page 140.
•
Danger
Check, tension and change belts only with the
engine o. Ret belt guard, if provided.
VD00034 VD02041