93
7 Lay-up / Winter storage procedure
Inspections and maintenance work to be carried out: page
1 Clean the engine, remove any salt. Paint any rust spots and spray the whole engine with a protective
medium, for example CRC protective 6-66.
94
2 Drain o the water from the fuel system and ll the fuel tank. 94
3 Make sure that the engine fuel system is lled with a fuel mixture with protective properties. 95
4 Flush out the raw water circuit with fresh water and if necessary ll with antifreeze. Clean the heat
exchanger if necessary.
96
5 Make sure that the cooling system is lled with a suitable anti-freeze. 97
6 Change the oil lter and the engine oil. 98
7 Change the oil in the gearbox. 98
8 Disconnect the battery cables, charge the batteries if necessary and grease the battery terminals. 99
To Next Page
Loading...
