VI.BE.MAC.S.p.A. 3022LV
Page 4
2. CONDITIONS OF USE
“Normal” operation includes all those operations for the preparation and application of waistbands onto trousers, respecting the
following conditions:
· the operator must first have read and fully understood all parts of this manual.
· the operator must abide by all the instructions in this manual and "CE" regulations.
· the maximum width of the waistband must be 103mm for a 1"1/2 Border Unit and 93mm for a 1"1/4 Border Unit or 100mm for a
Border 1” 3/8.
· the material thickness of the trousers where the waistband is to be applied must not be greater than 6 mm.
· all safety regulations must be respected; safety covers and devices installed by the manufacturer must not be removed.
· the electrical supply must be constant.
· the machine must be earthed to prevent disturbances and electric shocks.
· the machine must not be used in continuous cycle, by blocking the control pedal in any position
· the machine must not operate at high temperatures (above 40°c) or low temperatures (below 10°c).
· water or other liquids (with the exception of oil) must not get into the sewing machine.
· water or other liquids must not get into the control panel, solenoid valves and cylinders.
· the automatic unit must not be used in areas where there is explosive gas, powder or oil vapours.
· the machine must not be connected to a compressed air circuit containing water or other liquids in the pressure circuit.
· the machine must be connected to a compressed air circuit with a constant minimum internal pressure of 5.5 bar.
· the operator must use soundproof earplugs to prevent damage to the ear.
· installation of the machine and extraordinary maintenance must be performed by qualified personnel.
The manufacturer declines any responsibility for damage to persons or things caused by the machine in cases where:
· the unit is not properly installed on an even surface.
· Installation of the machine is not performed by qualified personnel
employees or technicians are not.
· eventual repairs (Mechanical and/or Electronic) of the machine are not performed by qualified personnel.
· the electrical supply is not constant.
· the air pressure in the pneumatic circuit is not constant and/or the quality of air does not satisfy the requirements.
· routine maintenance of the unit is not performed as required.
· non-original spare parts or parts which are not specified for the model are used.
· there is a partial or total lack of observance of the instructions on the part of the operator.
· the operator has been working with broken or unsuitable needles, thereby ruining the trousers.
· exceptional circumstances apply.
In no circumstances:
· remove the safety covers and devices from their position, thereby making the machine dangerous for the operator.
· remove the eye protection shield without supplying the operator with special eye protection glasses in compliance with current
regulations.
· deactivate the safety devices provided by the manufacturer, thereby making the machine dangerous for the operator.
· modify the machine, without authorisation from the manufacturer, thereby making the machine dangerous for the operator.
2.1. FORM OF GUARANTEE
A guarantee of 01 (one) year will be applied to all parts that make up the unit, when delivered to the manufacturer and found to be
defective. The guarantee is not applied for parts of normal use (example: Oil – Needles – Blades).
All parts damaged through improper use by the operator, and/or improper adjustment of the unit by technical personnel
not qualified by VI.BE.MAC., will NOT be considered as defective by the manufacturer. These will be charged for, including
all transport costs and/or subsequent installation costs.
To Next Page
Loading...
