VI.BE.MAC.S.p.A. 3022LV
Page 8
10. SETTING THE PULLER LIFTING PARAMETER
The following appears on the control panel display:
2 – 9 9
Press the down arrow , button B and button D at the same time.
+ B + D
The following will then appear on the display:
P - S (S mode)
Keep the two buttons pressed down until this changes to:
K s m. o f (S mode)
Press the down arrow until the following appears on the display:
K 11. x x Setting number of stitches to start to enable the Puller Lift . Standard value 0
Use buttons C and D to enter the desired number of stitches
Press the down arrow when the following appears on the display:
K 1 2. x x Setting number of stitches to keep lift the Puller. Standard value 10
Use buttons C and D to enter the desired number of stitches
Press the up and down arrows at the same time in order to exit this mode
To Next Page
Loading...
