VI.BE.MAC.S.p.A. 3022LV
Page 5
3. ORDER OF OPERATIONS
3.1.BEGINNING CYCLE
1) The operator insert the waist band inside the Straight Folder up to the waistband exits from if for about 3cm.
2) Inserts inside it the begin of the trouser and folds the front edge by fingers, after that inserts under the presser foot this
material, pushing forward the Folder near the Presser Foot in the same time.
3) The Photocell reads the material and the operator can now starts to run on the material keeping press the pedal on the
main motor.
The unit begins the seam cycle, after that “COC” stitches counter has arrived to the setting number it is
executed the chain cutter cycle and the Puller it is raised in the same time.
The Sequence Points K21 keep lift the Puller while the units runs for the follows stitches and after the setting number the Puller it is
lowered on the material.
3.2.END CYCLE
1) The operator when arrives near at the last 5cm of material stops the cycle, pull backward the Folder and insert in the
waistband the special pneumatic cutter
2) Push the button on the pneumatic cutter and makes the waistband cut at the correct length
3) Folds the final waistband edge by fingers and press again the pedal on the main motor keeping press it to finish the seam.
The unit automatically will stops at the correct position, the Puller keeps the material pulls to make properly the chain stitch
seam out of the material.
The Operator takes out the portion of waistband that remains inside from the Straight Folder and after that starts with a new cycle.
During this cycle after the Chain cutter the Operator will download the material from the unit.
To Next Page
Loading...
