Need help?Do you have a question about the Viking 30'' W and is the answer not in the manual?
Details electrical requirements including voltage, amperage, and wiring for single and double ovens.
Explains the function of the door lock control and timer, activated by line voltage and sensors.
Describes the auto reset switch as a thermostat controlling door lock and indicator light based on temperature.
Details the function and temperature cut-off points of the high limit switch.
Explains how the door lock motor, levers, and micro switches operate to lock and unlock the door.
Explains how selector switch positions energize relays for heating elements and door lock functions.
Lists voltage readings at various terminals when the oven door is open.
Lists voltage readings at various terminals when the oven door is locked.
Provides resistance and voltage readings for the bake element under different operating conditions.
Provides resistance and voltage readings for the broil element (inside and outside) under various modes.
Explains how the selector switch enables self-clean mode, energizing relays and controlling the door lock.
Describes how the auto reset switch affects door lock indicator and motor circuit above 575°F.
Describes how the auto reset switch affects door lock motor and timer circuit below 575°F.
Details the process of checking and adjusting oven temperature using the thermostat adjustment screw.
Illustrates the electrical connections for a 30" wide built-in single oven.
Details how the selector switch closes contacts for bake mode, powering elements and cycling thermostat.
Explains how selector switch closes contacts for convection bake, powering fan, bake, and broil elements.
Details how selector switch closes contacts for convection cook, powering fan and convection element.
Explains how selector switch closes contacts for mini broil, powering the inside broil element.
Details how selector switch closes contacts for convection broil, powering fan and both broil elements.
Explains how selector clean position activates circuits for self-clean, indicator light, and door lock motor.
Describes door lock motion stopping, cooling fan powering, and broil/bake elements activation.
Explains how the auto reset switch turns on the door lock indicator and disables the motor circuit.
Details how timer switches turn off the cooling fan and disable heating elements via Relay #1.
Explains how auto reset switches allow door lock motor operation and reset the timer.
Step-by-step instructions for removing the oven door, including using a pin and screw.
Details steps to remove trim, control panels, and component panels for access.
Step-by-step guide for connecting a 3-wire power supply cord to the terminal block.
Provides instructions and illustrations for fashioning a hook to manually release a locked oven door.
To Next Page
General
