Viking FDB451 - Changing a Program after the Unit Has Started; Opening Door after Cycle Starts

Operation
10 ©2012 Viking Preferred Service
Changing a Program After the Unit has Started
The dishwasher is programmed to stop operating if the door is opened during a cycle. To change
a program or option after starting the machine, open the door slightly to let the spray arms stop
rotating and avoid getting sprayed with water. Press and hold “START” for four seconds to cancel
the current selection, then press the touchpad(s) for your desired selection.
Press “START” again and close the door. The drain pump will run to remove any dirty water
from the dishwasher before starting the newly selected cycle. Check to make sure there is still
detergent in the detergent dispenser.
Opening door after cycle starts
If the door is opened after the cycle has started, the ”START” button will ash to indicate that the
dishwasher is in Standby Mode. Press the “START” button and close the door securely within 4
seconds to restart the cycle.