Operation
8 ©2012 Viking Preferred Service
ILLUMINATION OF BUTTONS
Options (continued)
Option, Cycle and Start buttons will only
illuminate after they are selected. The
"SANITIZED" indicator will illuminate when
the cycle has been completed. If your
dishwasher did not properly sanitize your
dishes, the indicator light will not illuminate.
This can happen if the cycle is interrupted
or the water could not be heated to the
required temperatures. The "SANITIZED"
indicator light goes off after you have
Cycle Data
Note: .Will perform properly if connected to "cold"
water (50
o
F / 10
o
C). Cycle times will be extended.
Note: All cycle times, temperatures and lls are
approximate and are dependent on installation and
environmental conditions.
Note: Heating delays to meet set temperatures may
extend the cycle times.
Note: AirFlo
TM
Gentle Drying will add approximately
one hour to the total cycle time.
POWER ON LIGHT
A blue light will illuminate from the bottom
kickplate panel in the middle when a cycle is
running. This powewr on light will blink if the
cycle is interrupted.
opened and closed the door or if you press
and hold the START/RESUME button. The
START/RESUME button will blink if cycle is
interrupted.
To Next Page
Loading...
