Viking FDB451 - Operation; Control Operation; Wash Cycles

Start
Resume
VIKING
• Vari-Pressure Intelli-Wash
• Quiet Clean System
• Airflo Gentle Dry
POTS NORMAL LIGHT FAST RINSE CLEAN
PANS WASH CHINA WASH HOLD
SANITIZED HI TEMP TOP SANITIZED DELAY
WASH WASH 155F RINSE START
2
4
6
8
10
CYCLES OPTIONS
Operation
©2012 Viking Preferred Service 7
Settings and Functions
Control Operation
The following is the basic layout of the control panel and how it is referenced below.
Wash Cycles
POTS / PANS
Heavily soiled pots, pans and casserole
dishes. Long heated prewash loosens up
encrusted food. High temperature main wash
and nal rinse.
Normally soiled plates, glasses, bowls, and
lightly soiled pots and pans. Energy-usage
label is based on this cycle.
NORMAL WASH
LIGHT/CHINA
Lightly soiled items, china and crystal. Lower
temperatures for cleaning delicate items.
RINSE/HOLD
All dishware. Short rinse with no heat.
Options
HI TEMP WASH
Increases the temperature, adding heat,
time and water for improved cleaning
performance. Available only with POTS/
PANS and NORMAL WASH. Note: Periods of
soaking will occur to aid in removal of baked
on soils
SANITIZED 155˚F RINSE
DELAY START
Lets you delay running the dishwasher for up
to 10 hours. To set “DELAY START”, select
the desired wash cycle and option(s). Press
the “DELAY START” button once and the
number “2” will light, indicating a two hour
delay. If you desire a longer delay, continue
pressing the “DELAY START” button to a
longer delay. The corresponding number on
the button will light. Once you have set the
desired delay time, press the “START” button
and close the door. “DELAY START” is not
available with the Rinse/Hold cycle.
Raises water temperature to 155˚F in the
nal rinse. Adds heat and time to the cycle.
This high temperature rinse sanitizes your
dishes and glassware in accordance with
NSF/ANSI STANDARD 184 for Residential
Dishwashers. Certied for residential
dishwashers and not intended for licensed
food establishments. Available only with
POTS/PANS and NORMAL WASH.
AUDIBLE SOUND SIGNAL
A single beep will occur when you select
cycles, options and press the “START” key.
If the “START” button is not pressed or if
the door is not closed within 4 seconds of
pressing the “START” button, 3 short beeps
will occur. The end-of-cycle signal consists
of 2 long beeps and activates 30 minutes
after the last drain, when the condensate dry
portion of the cycle is completed. For all other
error messages and to deselect the audible
sound signal, see the Troubleshooting/ Fault
Codes section.
FAST WASH
To remove light lms and residue on dishes
and glassware. Short wash times and varying
pressures.