Vimar Eikon 20461 - Initialising the Reader and Programming MASTER Smart Cards

ENGLISH - 43
7.1.5
When the LED turns off, the MASTER
smart card has been programmed.
7.1 Initialising the reader and
programming MASTER smart cards
This procedure generates a MASTER code in the memory of
the reader/programmer being initialised, and copies it to the
desired MASTER smart cards.
Important! During this phase, always program several
copies of the MASTER smart card (to be kept in a safe
place), because it will not be possible to make duplicates
at a later time.
7.1.3
Place dip-switch 2 in the ON position.
The LED lights up yellow.
7.1.2
Select the “Hotel” address
7.1.1
Power up the reader.
7.1.4
When the LED turns green (after about 10
seconds), insert the smart card to be pro-
grammed as the MASTER.
1
O
N
2 3 4 5 6 7
1 2 3 4 5 6 7 8
ON
MASTER
card
MASTER
card
1 2 3 4
6
7 8
ON
MASTER
card
MASTER
card
yellow
green
off