Vimar Eikon 20461 - Changing the Reader and Smart Card Codes

12 - ENGLISH
5.2.9
To exit the procedure, press the front but-
ton.
The LED blinks yellow 3 times, and then
turns off.
5.3 Changing the reader and smart
card codes
This procedure changes the code assigned to the address
of the reader/programmer, and saves it to the smart card.
5.3.1
Place dip-switch 1 in the ON position.
The LED lights up yellow.
If no smart cards are inserted for about 2 min-
utes, the procedure automatically terminates.
Exiting the procedure is signalled by the LED
blinking yellow 3 times.
5.3.2
When the LED turns green (after about 10
seconds) insert the smart card with the
code currently in use.
2 minutes
yellow
yellow
1 2 3
4 5 6
7 8
ON
Card being
duplicated
Card being
duplicated
yellow
green