ENGLISH - 13
5.3.6
When the LED turns off, the code in the
reader/programmer has been changed
and written to the inserted smart card.
The device waits for the smart card for about 2
minutes, after which the LED turns yellow and
no further commands are accepted. To resume
normal operation, place dip-switch 1 in the OFF
position.
5.3.3
When the LED turns off, the smart card
has been recognised.
If the smart card is not recognised, the LED turns
red and remains illuminated until the card is re-
moved.
5.3.4
Remove the smart card.
The LED turns green.
5.3.5
Insert the smart card again.
5.3.7
Remove the smart card.
The LED turns green again, waiting for
other smart cards to reprogram.
To reprogram additional smart cards, re-
peat the procedure from step 5.3.5.
2 minutes
green
off
yellow
green
green
off
To Next Page
Loading...