Vimar Eikon 20461 - Initialising the Reader and Programming SLAVE Smart Cards

44 - ENGLISH
If no smart cards are inserted for about 2 min-
utes, the LED turns yellow and no further com-
mands are accepted.
To resume normal operation, place dip-switch 2
in the OFF position.
7.2 Initialising the reader and
programming SLAVE smart cards
This procedure generates a SLAVE code in the memory of
the reader/programmer being initialised, and copies it to the
desired smart cards.
Each time the “Initialise reader and program SLAVE smart
card” procedure is invoked, a different code will be gener-
ated.
To carry out this procedure it is necessary to have the MAS-
TER smart card (see paragraph 7.1).
7.1.6
Remove the smart card.
The LED turns green again, waiting for
other MASTER smart cards to program.
To program additional MASTER smart
cards, repeat the procedure from step
7.1.4.
7.1.7
To exit the procedure, place dip-switch 2
in the OFF position.
7.2.1
Press the front button.
off
MASTER
card
MASTER
card
2 minutes
1 2 3 4
6
7 8
ON
green
yellow
off