Vimar Eikon 20461 - Page 103

ENGLISH - 45
7.2.3
When the LED stops blinking and turns
green, insert the MASTER smart card to
enable the procedure.
If the MASTER smart card is not inserted within 2
minutes:
• the LED blinks yellow 3 times
• the device exits the procedure
7.2.5
Remove the MASTER smart card.
The LED turns green again, waiting for a
SLAVE card to program.
7.2.6
Insert the SLAVE smart card to be pro-
grammed.
If the SLAVE smart card is not inserted within 2
minutes:
• the LED blinks yellow 3 times
• the device exits the procedure
7.2.2
The LED blinks yellow 3 times.
If the LED turns red, it means a SLAVE master
card or a non-enabled MASTER smart card was
inserted.
Remove the incorrect smart card and insert the
correct one.
7.2.4
If the MASTER smart card is recognised,
the LED switches off.
MASTER
card
MASTER
card
yellow
green
red
MASTER
card
MASTER
card
MASTER
card
MASTER
card
SLAVE
card
SLAVE
card
green
off
green