Vimar Eikon 20461 - 5 Operation Without a MASTER Smart Card; Initialising the Reader and Programming Smart Cards

8 - ENGLISH
5.1 Initialising the reader and
programming the smart cards
5. Operation without a MASTER smart card
This procedure generates a code, associates it with a select-
ed address in the memory of the reader/programmer being
initialised, and copies it to the desired smart cards.
5.1.1
Power up the reader.
Device and access control in the residential
and services sectors:
5.1.4
Place dip-switch 1 in the ON position.
The LED lights up yellow.
5.1.2
Place dip-switch 3 in the OFF position.
5.1.3
Select the desired address (see “Address
selection” table on page 6).
In the example, address A was used.
1
O
N
2 3 4 5 6 7
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
1 2 3
4 5 6
7 8
ON
yellow