Vimar Eikon 20461 - Duplicating SLAVE Smart Cards

ENGLISH - 25
This procedure can be used to create new SLAVE smart
cards at any time.
To carry out this procedure it is necessary to have the MAS-
TER smart card.
6.3 Duplicating SLAVE smart cards
6.3.3
When the LED turns green (after about 10
seconds), insert the MASTER smart card
within 10 seconds to enable the proce-
dure.
If the MASTER smart card is not inserted within
10 seconds:
• the LED blinks yellow 3 times
• the device exits the procedure
6.3.2
The LED lights up yellow.
If the LED turns red, it means that a SLAVE smart
card or a non-enabled MASTER smart card was
inserted.
Remove the smart card and insert the correct
one.
6.3.4
If the MASTER smart card is recognised,
the LED blinks green for the remaining
time that it is left inside the reader/pro-
grammer.
6.3.1
Press the front button.
off
yellow
MASTER
card
MASTER
card
green
red
green