24 - ENGLISH
6.2.4
Remove the MASTER smart card.
The LED turns green again, waiting for a
SLAVE smart card to program.
6.2.5
Insert the SLAVE smart card to be
programmed.
Warning! If the MASTER smart card is re-
inserted at this point, the SLAVE code will also
be written to it. To delete this card, use the
“Cancelling SLAVE smart cards” procedure
described on pg. 31.
6.2.6
When the LED turns off, the SLAVE smart
card has been programmed.
6.2.7
Remove the SLAVE smart card, the
LED turns green again, waiting for other
SLAVE smart cards to program.
To program additional SLAVE smart
cards, repeat the procedure from step
6.2.5.
6.2.8
To exit the procedure, place dip-switch 1
in the OFF position.
If no synchronising smart card is inserted the
LED turns yellow and no further commands are
accepted. In this case it is necessary to place
the dip-switch 1 in the OFF position to exit the
procedure.
1 2 3
ON
green
off
MASTER
card
MASTER
card
SLAVE
card
SLAVE
card
green
green
off
To Next Page
Loading...