14 - ENGLISH
Warning!
Any additional smart cards containing the
old code must be reprogrammed with
the new code, otherwise they can no
longer be used.
5.4 Cancelling smart cards
This procedure is used for cancelling smart cards.
Warning! At least one smart card must be left enabled, in
order to continue accessing the operating procedures.
5.3.8
To exit the procedure, place dip-switch 1
in the OFF position.
If no smart cards are inserted for about 2 min-
utes, the LED turns yellow and no further com-
mands are accepted.
To resume normal operation, replace dip-switch
1 in the OFF position.
5.4.2
The LED lights up yellow.
5.4.1
Press the front button.
1 2 3
ON
2 minutes
off
yellow
off
yellow
To Next Page
Loading...