ENGLISH - 15
5.4.4
Insert an already-programmed smart
card.
Warning!
It is necessary to keep at least one smart
card enabled.
The device waits for an already programmed
smart card for about 10 seconds, after which it
exits the procedure.
Exiting is signalled by the LED blinking yellow 3
times.
5.4.3
Press the front button again within 9 sec-
onds. The LED turns green.
Warning!
If the button is not pressed within 9 seconds, the
LED turns green and the device switches to the
“Duplicate Smart Card” procedure.
Wait 10 seconds to exit the procedure. Exiting
is signalled by the LED blinking yellow 3 times.
Repeat the procedure from step 5.4.1.
5.4.6
Remove the smart card.
The LED turns green.
5.4.5
The LED blinks green for as long as the
smart card remains inserted, indicating
that it has been recognised.
If the smart card is not recognised, the LED turns
red and remains illuminated until the card is re-
moved.
5.4.7
Insert the smart card to be cancelled.
The device waits for the smart card to be can-
celled for about 2 minutes, after which it exits the
procedure. Exiting is signalled by the LED blink-
ing yellow 3 times.
Card
already
programmed
Card
already
programmed
green
green
yellow
Card being
cancelled
Card being
cancelled
green
green
green
To Next Page
Loading...