Vimar Eikon 20461 - Synchronising Readers with SLAVE Smart Cards

ENGLISH - 37
6.8 Synchronise readers with SLAVE
smart cards
This procedure allows several readers to operate using the same
SLAVE smart card, the same address and the same SLAVE
code.
Synchronising a non-initialised reader
Before synchronising it is necessary to:
• initialise the reader being synchronised with a MASTER
code (procedure 6.1)
or
• synchronise the reader with the MASTER code (procedure
6.7).
6.7.14
Remove the smart card.
The LED turns green again.
6.7.15
To exit the procedure, place dip-switch 2
in the OFF position
If dip-switch 2 is not placed in the OFF position
within 2 minutes, the LED turns yellow and no
further commands are accepted. To resume
normal operation, place dip-switch 2 in the OFF
position.
1 2 3 4
6
7 8
ON
green
off