Vimar Eikon 20461 - Changing the Reader and SLAVE Smart Card Codes

ENGLISH - 29
6.5 Changing the reader and SLAVE
smart card codes
This procedure changes the SLAVE code assigned to the
address of the reader/programmer, and saves it to the smart
card.
To carry out this procedure it is necessary to have the MAS-
TER smart card.
6.5.1
Place dip-switch 1 in the ON position.
The LED lights up yellow.
If no smart cards are inserted for about 2 min-
utes, the LED turns yellow and no further com-
mands are accepted.
To resume normal operation, replace dip-switch
1 in the OFF position.
If the LED turns red, it means that a SLAVE smart
card or a non-enabled MASTER smart card was
inserted.
Remove the smart card and insert the correct
one.
6.5.2
When the LED turns green (after about 10
seconds), insert the MASTER smart card
to enable the procedure.
1 2 3
4 5 6
7 8
ON
yellow
2 minutes
MASTER
card
MASTER
card
green
red
yellow