Vimar Eikon 20461 - Page 86

28 - ENGLISH
6.4.5
Insert the MASTER smart card again.
Warning!
Any additional smart cards containing the
old code must be reprogrammed with
the new code, otherwise they can no
longer be used.
6.4.6
When the LED turns off, the MASTER
smart card has been reprogrammed.
6.4.8
To exit the procedure, place dip-switch 2
in the OFF position.
If no smart cards are inserted for about 2 min-
utes, the LED turns yellow and no further com-
mands are accepted.
To resume normal operation, place dip-switch 2
in the OFF position.
6.4.4
Remove the MASTER smart card.
The LED turns green again.
6.4.7
Remove the smart card.
The LED turns green again, waiting for
other MASTER smart cards to reprogram.
To reprogram additional MASTER
smart cards, repeat the procedure from
step6.4.5.
MASTER
card
MASTER
card
MASTER
card being
programmed
MASTER
card being
programmed
green
green
off
1 2 3
4 5 6
7 8
ON
green
off