10 - ENGLISH
5.2 Duplicating smart cards
This procedure can be used to make copies of smart cards
at any time.
Note: When duplicating smart cards that are enabled for sev-
eral readers/programmers, the procedure must be carried
out on each reader/programmer.
5.2.3
When the LED turns green (after about 10
seconds), insert an already-programmed
smart card within 10 seconds.
5.2.4
If the smart card is recognised, the LED
blinks green for the remaining time that it
is left inside the reader/programmer.
5.2.1
Press the front button.
5.2.2
The LED lights up yellow.
The device waits for an already programmed
smart card for about 10 seconds, after which it
exits the procedure.
Exiting the procedure is signalled by the LED
blinking yellow 3 times.
off
yellow
Card
already
programmed
Card
already
programmed
yellow
green
green
To Next Page
Loading...