ENGLISH - 11
If the smart card is not recognised, the LED turns
red and remains illuminated until the card is re-
moved.
If a succession of unrecognised smart cards are
inserted, the device exits the “Duplicate Smart
Card” procedure about 10 seconds after inser-
tion of the last unrecognised card. To resume
duplicating cards, repeat the procedure from
step 5.2.1.
If the LED turns off, repeat the procedure from
step 5.2.1.
5.2.7
When the LED turns off, the duplicate
smart card has been programmed.
5.2.5
Remove the smart card.
The LED turns green.
5.2.6
Insert the smart card to be programmed.
The device waits for the smart card to be pro-
grammed for about 2 minutes, after which it exits
the procedure. Exiting is signalled by the LED
blinking yellow 3 times.
5.2.8
Remove the smart card.
The LED turns green again, waiting for
other smart cards to program.
To duplicate additional smart cards, re-
peat the procedure from step 5.2.6.
red
green
Card being
duplicated
Card being
duplicated
green
off
green
To Next Page
Loading...