Vimar Eikon 20461 - Page 88

30 - ENGLISH
6.5.5
Insert the SLAVE smart card to reprogram.
Any other SLAVE smart cards containing
the old code must be reprogrammed in or
-
der to continue being used.
If no smart card is inserted for about 2 minutes,
the LED turns yellow and no further commands
are accepted.
To resume normal operation place dip-switch 1
in the OFF position.
6.5.6
When the LED turns off, the SLAVE smart
card has been reprogrammed.
6.5.8
To exit the procedure, place dip-switch 1
in the OFF position.
If no smart cards are inserted for about 2 min-
utes, the LED turns yellow and no further com-
mands are accepted.
To resume normal operation, replace dip-switch
1 in the OFF position.
6.5.4
Remove the MASTER smart card.
The LED turns green again, waiting for a
SLAVE card to reprogram.
6.5.7
Remove the smart card, the LED turns
green again, waiting for other smart cards
to reprogram.
To reprogram additional smart cards, re-
peat the procedure from step 6.5.5.
6.5.3
If the MASTER smart card is recognised,
the LED switches off.
MASTER
card
MASTER
card
MASTER
card being
programmed
MASTER
card being
programmed
MASTER
card
MASTER
card
off
green
green
1 2 3
4 5 6
7 8
ON
off
green
off