36 - ENGLISH
6.7.10
The LED turns off to indicate that the
smart card has been recognised.
If the smart card is not recognised, the LED turns
red and remains illuminated until the card is re-
moved.
6.7.12
Insert a MASTER smart card, already pro-
grammed by the synchronising reader/
programmer, into the reader being syn-
chronised.
If no synchronising MASTER smart card is insert-
ed within 2 minutes, the LED turns yellow and
no further commands are accepted. In this case
it is necessary to place dip-switch 2 in the OFF
position to exit the procedure.
6.7.11
Remove the smart card which has been
recognised.
The LED turns green.
6.7.13
The LED switches off to signal that the
MASTER smart card code has been cop-
ied, and the reader/programmer synchro-
nised.
The device waits for the currently active MASTER
smart card for about 2 minutes, after which the
LED turns yellow and no further commands are
accepted.
To resume normal operation, place dip-switch 2
in the OFF position.
2 minutes
yellow
off
green
Synchronising
card
Synchronising
card
green
off
To Next Page
Loading...